24
EN
Error 6
Temperature sensor broken.
Replace
the
temperature
sensor
The charger is set for use of
the temperature sensor, but
the sensor isn’t present.
Change the charging program
(page 16-19).
Charger doesn’t work.
No mains voltage.
- Measure the mains voltage.
It should be higher than
180VAC (95VAC for 115VAC
input).
- Have the internal fuse
checked by your dealer.
The Power LED lights, but
the charger doesn’t work
Mains voltage to low.
Measure the mains voltage.
It should be higher than
180VAC (95VAC for 115VAC
input).
The charger gives the correct
indication but the battery is
not charging. The charger
does not supply the correct
voltage (and current).
The charger is busy with its
soft start.
3 minutes after switching on
the
charger,
the
correct
charge level is indicated.
Charger doesn’t deliver its
maximum charging current
Mains voltage to low.
Measure the mains voltage.
Below a voltage of 200VAC
(100VAC for 115VAC input)
the charger can’t deliver its
complete charging current.
Battery doesn’t fill up, the
red or yellow LED continues
to burn.
The battery is defective
Measure the acid and replace
the battery if necessary.
There are heavy consumers
connected to the battery.
Turn off as many consumers
as possible.
Battery is too heavy for the
charger
Ask your supplier for advice.
The voltage you measure on
the output terminals is too
high
The charger automatically
compensates for the voltage
drop over the cables.
Measure the voltage on the
battery terminals.