XciteRC X-6S, User Manual

Page: 37 / 80

37 50500000 Sender X-6S 37
M O D E L M 0 0 1
R E N A M E
S A V E A S
R E C O V E R
M O D E L M 0 0 1
R E N A M E
S A V E A S
R E C C V E R
R E C O V E R . .
ENTER
345
S Y S . M E N U
M O D E L S E T
P L A N E T Y P E
S T I C K M O D E
S Y S . M E N U
M O D E L S E T
P L A N E T Y P E
S T I C K M O D E
M O D U L A T E
H E L I C P L A N E
V - T A I D E L T A
ENTER
345
STICK
RUDD
S T I C K M O D E
M O D E 1
R U
E L
A I
T H
S T I C K M O D E
M O D E 2
R U
T H
A I
E L
S T I C K M O D E
M O D E 3
A I
E L
R U
T H
S T I C K M O D E
M O D E 4
A I
T H
R U
E L
EN
System menu
• Press “up” or “down” to select the setting Item, and press “ENTER” to come to “SAVE AS” .
• Press “ up” or “down” to select your model number to be saved. Press “ENTER” to confirm when the
number is selected. It can be saved again and again in different model number groups. Press “EXIT” to
leave the setting.
Remark: the data of the current model number group will overlay another data group, so please be careful.
Recover the factory data
• Press “down” to select “SYS MENU” and press “ENTER” to come to the interface.
• Once again press “ENTER” to come to “MODEL SET” interface, and now the shadow area Is the item
that can be set currently.
• Press “ up” or “down” to select the setting item,and press “ENTER” to come to ”RECOVER” .
• Press “ ENTER” to recover the factory setting. and press “EXIT” to leave the menu.
Remark: This recovery will clear the data of the current model number, please be careful.
Plane type
Plane type selection
• Press “down” to select “SYSMENU” and press “ENTER” to come to the interface.
• Press “up” or “down” to select “PLANE TYPE” ,and now the shadow area is the item that can be set
currently. Press “ENTER” to go to the next step.
• Now comes out a dialing box, Press “up” or “down” to select ‘ HELIC ‘ , ‘ PLANE ‘ ,
• ‘V-TAIL ‘or ‘DELTA ‘.And press “ENTER” to save the setting and leave the operation.
Stick Mode
Stick mode selection
• Press “down” to select “SYSMENU” and press “ENTER” to come to the interface.
• Press “up” or “down” to select “STICK MODE” ,and now the shadow area is the item that can be set cur-
rently. Press “ENTER” to go to the next step.