X8222r User’s Manual Version 1.0
- 12 -
VII. Default Values
X8222r
is pre-configured with the following parameters; you may
also re-load the default parameters by pressing the reset button of
the modem for about 10 seconds or by using the
System
Commands
link in the Web interface.
Note:
The User Name and Password are case-sensitive.
Username/Password
: admin
Default IP Address
WAN and ADSL
Ethernet (local) IP: 192.168.1.1
Local Line Code: Multi Mode
Subnet mask: 255.255.255.0
DHCP Server:
Disable
Protocol
DHCP start IP: 192.168.1.2
RFC1483 Bridge: VPI/VCI: 8/35
DHCP end IP: 192.168.1.254
Class (QoS): UBR
DNS
Relay:
Disable
X8222r User’s Manual Version 1.0
- 13 -
VIII.
Software Upgrade
You may easily upgrade
X8222r
embedded software by obtaining the
compressed upgrade kit from the service provider and then following
the steps to upgrade the software of
X8222r
using a web-browser:
Software upgrade through a web-browser
Step 1. Extract the ZIP file for updated firmware.
Step 2. Connect
X8222r
via the local Ethernet port, make sure
that the
X8222r
Ethernet IP address and your terminal are
properly configured so that you can successfully ping
X8222r
. The default local IP address is 192.168.1.1.
Step 3. Launch the Web browser (IE or Netscape), and enter the
default IP address 192.168.1.1 into the address bar to
access the Web management page.
Step 4. Click on the
Maintenance
link in the navigation bar and
then on the
Upgrade Gateway
link below it.
Step 5. Click on the
Browse
button to select the upgrade file.
Step 6. Click on the
Update
button when completed.
Step 7. Update ram_zimage_pad.ar7rd.nsp.squashfs.upgrade,
then Update nsp.annexA.upgrade.img.
Note
: Strictly maintain stable power to
X8222r
while upgrading its
software. If the power fails during the upgrading process, contents in
the memory could be destroyed, and the system may hang. In such a
case, you must call the dealer or system integrator for repairs.
