![background image](http://html1.mh-extra.com/html/xantrex/freedom-sw-230v/freedom-sw-230v_installation-manual_3209513080.webp)
66
Freedom SW 230V Installation Guide
Specifications
NOTE
: All charging specifications are at nominal conditions: ambient temperature of 25 °C, 230 VAC, 50 Hz input, unless
otherwise specified.
Charger Specifications
Freedom SW 2524-230
Freedom SW 3524-230
Charging method
Three-stage charge (Bulk, Absorption, Float)
Two-stage charge (Bulk, Absorption)
The default charging method is three-stage.
Without a battery temperature sensor
Three settings with the following temperature values:
Cool 10 °C
Warm 25 °C
Hot 40 °C
The default setting is Warm and it can only be changed by the factory, a dealer, or a service centre.
With a battery temperature sensor (included)
The temperature compensation coefficients on a 24-volt battery are as follows:
Flooded: 54 mV × (25 °C – BTS °C)
Gel: 54 mV × (25 °C – BTS °C)
AGM: 42 mV × (25 °C – BTS °C)
Output current (maximum)
65 ADC
90 ADC
Output voltage
24 VDC
24 VDC
Output voltage range
12.0–32.0 VDC
12.0–32.0 VDC
Equalization cycle
Automatic, Manual by Xanbus SCP
Automatic, Manual by Xanbus SCP
Optimal charging efficiency
> 85%
> 85%
AC input power factor (at full charge rate)
> 0.98
> 0.98
AC input current
10.6A max. (excluding pass-through)
14A max. (excluding pass-through)
AC input voltage
230 VAC
230 VAC
AC input voltage range
170–270 VAC
170–270 VAC
Dead battery charge voltage
> 12.0 VDC
> 12.0 VDC
AC input type
Single input (up to 30A)
Single input (up to 30A)
Circuit breaker (resettable)
30A
30A
FSW 230V Installation Guide.book Page 66 Tuesday, August 7, 2018 9:18 AM