Xantrex Freedom Sequence, Installation Manual

Page: 26 / 32

16 Freedom Sequence Intelligent Power Manager Installation Guide
Installing the Freedom Sequence
Step 5: Interconnecting the Xanbus Components Step 6: Powering up the SCP
TM
TM
C US
RR
TM
XANBUS INTERFACE STACKING
RESET
INVERTER
ENABLE
INVERTER
ON
AC/
CHARGE FAULT
FREEDOM SW INVERTER/CHARGER
XANBUS INTERFACE STACKING
RESET
INVERTER
ENABLE
TM
C US
RR
XANBUS INTERFACE STACKING
RESET
INVERTER
ENABLE
INVERTER
ON
AC/
CHARGE FAULT
FREEDOM SW INVERTER/CHARGER
XANBUS INTERFACE STACKING
RESET
INVERTER
ENABLE
(1) Pick the Xanbus SCP as the first Xanbus component in the network. Plug the SCP’s left Xanbus
network port with a network terminator. (2) Using a CAT5 network cable, plug the SCP’s right Xanbus
network port with one end of the network cable. Plug the other end of the network cable into the next
component’s left Xanbus network port. Daisy-chain the other components as shown.
(3) Terminate
the daisy chain by plugging the right Xanbus network port of the last component with a network
terminator.
NOTE
: In a Xanbus network, the components’ arrangement is immaterial (see Example 2).
The only condition is that the first and last components need to be properly terminated.
Example 2
Example 1
(1) Close the DC battery disconnect to energize the Xanbus SCP. (2) Observe the Xanbus SCP’s
display panel, make sure it is receiving power from the system. (3) Bring the Freedom Sequence to
Safe Mode from the Config screen of the SCP. Refer to the Owner’s Guide for detailed instructions.
INVERTER
SUBPANEL
FREEDOM
SW
3012
FREEDOM
SW
3012
In ve
rter
R eset Enab
le
Inv er te
r AC/
On
Char
ge Fa ult
Inverter/Charger
MAIN AC
PANEL
BATT
DC AUX
HARNESS
AGS
TM
SCP
TM
BATTERY
BREAKER
AC IN
AC IN
AC IN
AC OUT
AC OUT
AC OUT
FSPM 00: Config
Mode
SHR BKR Mode
SHR BKR Rating
Circuit Config
[*Safe]
[Auto]
[30.0A]
FSequence IPM Install Guide.book Page 16 Thursday, October 6, 2011 3:21 PM