975-0593-01-01
7
Features
This
gu
id
e for
us
e by qu
alifi
ed installers only.
Tools and Materials
,
Location
Install the power manager in a location that meets the following
requirements:
Tools
3.5mm blade long neck screwdriver for opening
the AC relay cage clamp connectors
Phillips screwdriver for removing and replacing
the AC Main panel cover
power drill/screwdriver
drill bit set for drilling pilot holes
wire stripper
Materials
Qty
three-conductor plus bare ground AC Main cable – four-wire cable
(see recommendations on page 9)
as needed
two-conductor plus bare ground AC Relay cable – three-wire cable
(see recommendations on page 9)
as needed
wires to splice correspondingly with the wires on the supplied DC
auxiliary connector wiring harness
as needed
AC Main cable one-inch metal strain relief
2
M5 Phillips pan head mounting screw or drywall anchor or plasterboard
plug. Select the best mounting material suited to the type of surface.
6
M5 washers at 10mm OD max
6
Condition
Requirement
Dry
The power manager must be installed in a dry location not subject to
moisture especially rain, spray, or splashing bilge water.
Clean
The power manager should not be exposed to metal filings or any other
form of contamination.
Cool
The ambient air temperature should be between 0 – 50 °C (32 – 122 °F) for
best performance.
Controlled
Environment
By definition, a controlled environment is clean and can be provided by
means of a totally closed, gasketed enclosure or the equivalent.
EXPLOSION HAZARD
Do not place the power manager in machinery space or in areas
containing gasoline tanks or fittings in which ignition-protected
equipment is required.
Failure to follow these instructions will result in death or serious
injury.
FSequence IPM Install Guide.book Page 7 Thursday, October 6, 2011 3:21 PM
Summary of Contents for Freedom Sequence
Page 2: ...FSequence IPM Install Guide book Page ii Thursday October 6 2011 3 21 PM...
Page 10: ...FSequence IPM Install Guide book Page ii Thursday October 6 2011 3 21 PM...
Page 30: ...FSequence IPM Install Guide book Page 20 Thursday October 6 2011 3 21 PM...
Page 31: ...FSequence IPM Install Guide book Page i Thursday October 6 2011 3 21 PM...