2.0 INSTALLATION
©2001 Xantrex Technology Inc.
P/N 975-0027-01-01 Rev A 09/01
8
Mounting
• Remove the two Phillips screws from the unit’s front panel and remove the
cover. Figure 2-2.
• Open the inverter’s access panel and locate the AUX connector if necessary.
Refer to the inverter operator’s manual for the location of the connector.
• Hold the ALM against the surface to be mounted and use the unit as a
template to mark the four hole locations. See Figure 2-3.
NOTE: Six holes are provided in the back panel of the
ALM. Use the two top and two bottom screw holes. Do
not use the middle two holes.
• Drill holes for mounting and insert appropriate anchors if necessary.
• Use four #10 wood screws to mount the unit to the wall or other vertical
surface.
• Install conduit runs or strain reliefs for the RY9 and RY10 control wires, error
indicator (if used), and communication cable (between the inverter and ALM).
Figure 2-2
Removing the Front Cover
Remove the 2
Phillips screws
Summary of Contents for ALM - REV A
