RS2321X8 Serial Router
Page 11
b. In Dragon Drop-IR SPLCD (this example assumes you are using the Xantech SmartPad LCD Controller),
click on the PALETTE Menu and click on Select RC68+ Command Palette from the drop-down menu (or
simply press F5 on your keyboard). You should now see the Virtual RC68+ Command screen.
c. Select the OPTIONS tab as shown on the Virtual RC68+ Command screen.
d. Under XANTECH MODEL, make sure it is selected to either RT16-10 or RT8 (RT16-10 should be chosen
by default).
e. Change the CODE GROUP to
90
as shown in
Figure 7
above. (Overlay should be selected to
C
)
f. Click on the proper Router button as shown on the RC68 (Button 1, 2, 3….8).
4. Open the RS232 Palette for Vantage and place the proper Macro commands under the IR Routing command in
step 8-f. See
Figure 10.
Note:
A 1 second delay might be needed in between the IR Router command and the RS232 command. If 1 Second
is too long try placing a ‘dummy’ IR command instead of the delay (this will be the equivalent of a .3sec delay.
Figure 9: Multiple SmartPad™ LCD panels Controlling a single RS232 Device
© 2005 Xantech Corporation
