X4-TECH MCD-4030, Instruction Manual

Page: 28 / 36

28
Note:
The programming for the time is NOT retained
if the device is separated from the power network.
Select operational mode
• Press the button
FUNCTION
repeatedly until the
required mode is shown in the display.
You can select from the following modes:
CD (CD playback)
USB (Playback of MP3 files from a
USB memory stick)
CARD (Playback of MP3 files from a
memory card)
AUX (Playback of an audio device
connected to the connection
AUX IN
)
TUNER (Radio mode)
To control the Volume
• To raise the sound volume, press the button
on the remote control or on the front of the device.
• To lower the sound volume, press the button
VOLUME-
on the remote control or on the front of
the device.
The selected volume level is briefly shown in the dis-
play.
Switch off sound
• To switch the sound off, press the button
MUTE
on the remote control.
The indicator MUTE flashes on the display.
• To switch the sound back on, press the
MUTE
once again or press one of the
VOLUME
buttons.
Sound adjustment
You can adapt the sound quality to the respective
type of music by means of the sound setting. You
can choose between the following settings:
POP - JAZZ - FLAT - CLASSIC - ROCK
• Press the button
EQ
repeatedly until the required
sound adjustment is indicated in the display.
If you adjust the sound setting while playing, the
sound will change immediately.
In the setting
FLAT the sound is played back un-
changed.
Setting the Clock
You can only adjust the clock in standby mode.
1.
Press the button
MEM CLK-ADJ
or
PROG/MEM
. The
hour indicator blinks in the display.
2.
To set the hours, press the buttons
SKIP
or
SKIP
.
3.
To save the setting, press the buttons
MEM CLK-ADJ
or
PROG/MEM
. The minute indicator blinks in the
display.
4.
To set the minutes, press the buttons
SKIP
or
SKIP
.
5.
Press the buttons
MEM CLK-ADJ
or
PROG/MEM
.
The time is now programmed and activated.
Note:
The programming for the time is NOT retained
if the device is separated from the power net-
work or switched off with the power switch.
Setting the alarm function (timer)
You can program your micro-system to wake you up.
For this purpose you can set the desired waking time,
the sound source and the volume. The micro-system
will then switch itself on and off according to the set
time. You can choose to be woken by the radio or by
sounds from a CD, memory card or a USB memory
stick.