18
3.
Remove entire Seat and Seat Barrel from scooter.
4.
Unscrew your old controller from the frame - Leave wires connected.
5.
Mount the New Controller in its location.
6.
Transfer One Connector at a time from the old controller to the new controller.
7.
Re-install Battery.
8.
With drive wheel not touching any surface Test Run and confirm all functions are working.
9.
Re-assemble and test ride.
10. This is also a good time to perform the recommended maintenance as listed in the Handbook.
How To Replace Rear Inner Tube
1.
Remove the seat and seat barrel. 4 screws need to be removed, 2 by the hinge and 2 down
inside and remove from scooter.
2.
Follow the wire coming out of side of motor and cut the tie straps leading up the controller.
3.
Remove the wheel nuts and remove the brake adjustment nut and remove the wheel.
4.
Let all air out of tire and use either a tire wrench or couple dull screw drivers to remove tire
bead from one side of rim to remove and install the tube.
5.
Install in reverse order make sure that the motor nuts are on extremely tight, use a 2 1/2'
crescent wrench to tighten them.
How To Replace Dash
1. First remove the four screws on the black gooseneck cover below the handle bars.
2. Then you will be able to remove the headlight faring. It will slide down and forward.
3.
Unhook the wires to the headlight and set the headlight faring aside.
4. Then you remove 5 screws on the back of the handle bars.
5. There is 1 screw on the front of the handle bars, also remove that.
6. Remove the mirrors from the scooter by turning counterclockwise.
7. Now the handle bar faring is ready to be removed, Start on the left side by where you
removed the mirror. Gently pull the front and back of the handle bar fairing apart. It should
snap apart fairly easily. Work your way across until the top is completely apart.
8.
Remove and replace.
9.
Reverse the order to reassemble.
How To Check Brake Safety Switch
1.
First remove front fairing and check the throttle connector and brake connectors for loose