X-Stream CLEAN Volt XCMADD, Operation Manual

Page: 14 / 24

14.
Copyright ©WESSOL, LLC
STEP 3.
AFTER YOU FINISH SPRAYING
A).
Dispose of extra liquid/chemical based on
manufacturer’s instructions. Rinse out any residual
solution in the spray tank with warm, soapy water. Then
spray fresh water through the sprayer for 3 to 5 minutes
to completely clear the tank, pump, gun, wand, and any
used nozzles of chemicals.
B).
Disconnect the hose from the spray gun and let the
hose hang down towards the ground in order to drain
the hose of any liquid.
C).
Dry the sprayer tank and clear the nozzle of any buildup.
D).
Store the sprayer in a clean, dry, and shaded location to
protect it from extreme heat or frost.
E).
Place any unused nozzles and nozzle washer into the
small accessory pouch until ready to spray.
*
For long-term storage, regular charging of the battery
is required to maximize battery life. Check the battery
level using the indicator lights every 4 weeks. Recharge
the battery if it falls below 3 bars. Do not allow the
battery to fully discharge.
Proper sprayer maintenance is crucial to ensure the extended life and performance of your sprayer. Many spray materials can harden if left in the sprayer,
causing clogs in the nozzle or hose. Gasoline should never be used to clean out your sprayer.