G E T T I N G S T A R T E D
22
Switch Only
– The instrument read switch initiates a
measurement.
Key Only
– The Read key on the instrument must be
pressed to initiate a measurement.
Switch and Key
– Both the instrument’s read switch
and read key are required to initiate a measurement.
•
Cal Timeout
– Determines the “cal interval time” desired
between calibrations. Time is set in hour increments and
can also be set to Off. When a calibration is required, a
message appears on the instrument screen informing you
that a calibration is needed.
•
Power Down
– Determines the amount of time the unit
remains on without any use before turning itself off. This
configuration only affects the instrument when the charger
is
not
connected. This value can range from 10 to 240
seconds.
•
Beeper
– Sets the volume of the beeper: Loud, Medium,
Soft, or Off.
•
Clock Adjust
– Used to adjust the internal clock of the
instrument.
•
Display
– Allows you to determine the following settings:
Contrast
– Set the contrast of the display for optimal
viewing. The setting can vary from 1 to 99.
Orientation
– Determine whether you want the
display viewable for right-handed (right) or left-
handed (left) use.
Security
– Enable (on) or disable (off) the entire
Configuration options menu.
See following steps to
access the Configuration menu when Security is enabled.
To gain access to the Configuration menu if
Security is enabled:
1.
Remove the AC adapter and turn off the instrument
with the battery switch.
2.
Press the Read key as you turn the instrument on
with the battery switch.
3.
When the main menu appears, release the Read key.
The Configuration item appears in the main menu.
NOTE:
You must set the Security to
Off
if you want the
Configuration item to automatically appear the next time
you turn the instrument on.
