![background image](http://html2.mh-extra.com/html/x-metal/dc8810/dc8810_installation-and-operating-manual_5001108013.webp)
13
ENGLISH
CONNECTING WITH THE AWNING
CONNECTING THE WIND/SUN SENSOR TO THE AWNING
First, check the direction of extension of the awning by rolling it out about 1 m and then slightly retracting it.
To ensure that the sensor is connected and functioning correctly, the UP button on the remote control MUST lift the awning. If
not, reassign the remote control according to the diagram below to change the direction of rotation, otherwise the awning will
extend in the wind.
NOTE
The programming process (pressing the buttons) must be performed within 6 seconds, otherwise it will
stop.
Connect the power supply to the wind and sun sensors.
Turn on the awning's power supply.
Press the P2 button twice on the remote control.
Press the P2 button once on the wind sensor.
The wind sensor will indicate the radio connection with a red LED light and the awning will emit a confirmation beep.
Your wind and sun sensor is now linked to your awning and ready to use.
CHANGE THE MOVEMENT DIRECTION OF THE AWNING
NOTE
Before performing the following steps, disconnect the awning.
OK
Setting button (P2)
Press and hold the
button.
Switch on power
Setting button (P2)
Press the UP button
twice in a row
Press the button
briefly
The procedure may differ slightly depending on the remote control or awning type.