7
UNFOLDING THE FRAME
Undo the folding blockade (a). Unfold the frame by lifting the handle until the locks click into
position (b).
WARNING:
Before use, make sure that the folding mechanisms are blocked.
FOLDING THE FRAME
Take the carrycot or seat unit off the frame. Unblock the locks on both sides of the stroller by
pressing the pedals marked as 1 (fig. a) and 2 (fig. b) in sequence. Fold the frame as shown below
(fig. c).
MOUNTING OF THE FRONT WHEEL
In order to mount the wheel, slide it onto the axle until the lock is engaged.
DISMOUNTING OF FRONT WHEEL
In order to take the wheel off, push the button shown on the figure, and pull the wheel
off the axis.
ASSEMBLY AND DISASSEMBLY OF REAR WHEELS
To assembly or disassembly the wheel, push rubber button, which is in the middle of the wheel.
WHEEL BLOCKADE
The stroller is provided with swiveling front wheels. A special lever blocks the wheel
swiveling movement. After the lever has been pressed, the wheels will only move for-
ward. To release the blockade, lift the lever.
INFLATING WHEELS
To inflate a wheel, unscrew the valve’s cotter. Place the pump on the valve and inflate
the wheel. The maximum allowed wheel pressure is 1.5 bar.
INSTALLING OF THE BUMPER BAR
Push in the ends of the bumper bar into mounting holes, until locks are snapped.
TAKING THE BUMPER BAR OFF
Push in the buttons of the bumper bar locks and slide its end out of the mounting holes.
The bumper bar may be tilted, when undone only from single side.
FOOTREST ADJUSTMENT
Press the buttons on both sides of footrest and adjust it to the required position.
BACKREST ADJUSTMENT
Pick up the tie and put up the backrest in required position.
AT TACHING THE SHOPPING BASKET
Push the plastic latches on the basket into the assembly bolts.
BRAKE
To apply the brake: push the pedal down with your foot. To release the brake pick its bar up.
FIT TING THE CARRYCOT OR SEAT UNIT
To fit the carrycot or seat unit open the adapter locks on both sides of the chassis. You
need to pull them upwards as shown in picture (a) until they click open. When the locks
are open, align the carrycot or seat unit with the locks and push it until the locks have
engaged (picture b).
Caution
: Before using the attached carrycot or seat unit you need
to ensure that it is properly fitted into place.
REMOVING THE CARRYCOT OR SEAT UNIT
To remove the carrycot or seat unit press the notch-unlocking buttons (1 picture a) and
pull it up out of the locking devices (a). Fold the locks by pushing the open part down as
shown in picture (b).
FIT TING THE CAR SEAT
In order to fit the car seat open the adapter locks by pulling them upwards until they
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
ENGLISH