X-IO ISE-2 Series, User Manual

Page: 83 / 178

Xiotech—Proprietary 160337-000 Rev D, 30 September, 2013 Page 75
ISE Management ISE User Guide
CLI
To initiate immediate transmission of the Telemetry data file, enter the following command at the CLI prompt.
telemetry send [-ipaddress= nnn . nnn . nnn . nnn ]
where
nnn . nnn . nnn . nnn
is the IP address of an
ISE Analyzer Software Service
expressed in IPv4-standard
format. The
-ipaddress
option can be omitted if the intention is to send telemetry to all
ISE Analyzer Software
Service
subscriptions. If a specific
ISE Analyzer Software Service
is desired, select it with the
-ipaddress
option. For example:
telemetry send
sends the Telemetry file to all
ISE Analyzer Software Service
subscriptions.
telemetry send -ipaddress=10.20.30.40
sends the Telemetry file to 10.20.30.40.
Note.
Do not use the
telemetry send -file
unless instructed to by
X-IO
Customer Support.
Volume and Host Configuration
Orchestrator
To view ISE volume configuration by pools using the Orchestrator, select
All Devices
>>
ise_name
>>
Storage
View
>>
Storage Pools
. (See the
Orchestrator User Guide
.)
Web-Mgt, View Volumes
To view ISE volume configurations by pools, open the
Detailed Volume Information
page as follows:
1. Open the
Volume Summary
view by placing the pointer over the
Storage
tab and selecting
summary
.
2. Expand the Pool navigation trees in the left navigation pane (shown in Figure 50 below).
3. Open the
Detailed Volume Information
page by clicking on the volume name (ref. 1 in Figure 50) in the
expanded pool navigation tree or in the first column of the
Volume Information
(ref. 2 in Figure 50) section
of the page.
When volume-host mappings exist, hosts mapped to the volumes are shown in the
Mapping
column of the
Volume Information
section.