Technical Support: [email protected] US: +1 866 677 0053 EU: +44 (0) 1793 230 343
9
EDID & DIST
ANCE SETTING
Distribution of HD signals through devices requires
mutual communication or ‘handshake’ between source
and display. If there is any disparity between the two,
successful transmission becomes problematic.
EX-1UTP-IR-50 / EX-1UTP-IR-50-POH extender
sets comes equipped with EDID management on the
Transmitter to encourage communication between INPUT
and OUTPUT devices and Distance SETTINGS on the
Receiver to toggle Long Cable mode ON/OFF should the
length of the cable run impact transmission quality.
If compatibility or transmission issues arise during
installation, check the settings on your connected devices
and adjust the DIP settings as required.
ATTENTION
Changes to DIP settings become
effective upon powering ON baluns. Changes to
settings should be made with all devices OFF, ideally
with all power cables and HDMI leads and UTP
cables removed to guard against electrostatic build
up that may damage your system.
DO NOT HOTSWAP your cables when changing DIP
SETTINGS.
ATTENTION
Make sure switches are set to
DEFAULT for initial installation.
Remove all cables and power supply for switch
changes to take effect. Switch settings become
active on re-boot.
NOTE
For ease of installation and convenience on
site, we have printed the DIP SETTINGS for both
Transmitter and Receiver on the base of the units.
9. EDID & Distance Setting
Transmitter
Default: EDID set to copy HDMI Output EDID
Receiver
Default: Long cable setting OFF
3
ON
1 2
Transmitter
EDID set to 1080p Stereo - 3D
Receiver
Long cable setting on
3
ON
1 2
Transmitter
EDID set to 1080p 2ch Stereo - 2D
Receiver
Reserved for future use - no function
3
ON
1 2
Transmitter
EDID set to 1080i 2ch Stereo - 2D
Receiver
Reserved for future use - no function
3
ON
1 2
Transmitter
EDID set to 1080p 5.1 - 2D
Receiver
Reserved for future use - no function
3
ON
1 2
Transmitter
EDID set to 1080p 7.1 - 2D
Receiver
Reserved for future use - no function
3
ON
1 2
Transmitter
Receiver
ATTENTION
We do not recommend passing power
remotely over excessively long cable distances as
this can affect the performance of the product.
NOTE
A 5v power input is included on the
Receiver for optional use should power issues be
encountered at the Transmitter location.
