800.255.3126 | wyeastmedical.com
51932 R07 Summit Powered Sit-to-Stand
Operator’s Manual
Page 9 of 24
SUMMIT
Operator’s Manual
FEATURES:
Install/Uninstall Footrest:
To remove the footrest, lift up by holding the yellow cross
bar and handle (see Fig. 1).
a. Raise the footrest 2 inches vertically.
b. Remove as shown.
Shin Guard Cam Lever:
1. To clamp, rotate the lever clockwise.
2. To re-position the lever at an angle to allow clamping,
pull the yellow handle back (see Fig. 2a), rotate to
desired position (see Fig. 2b) and release.
3. You are now ready to rotate to clamp.
Shin Guard Adjustment Toward/Away from Patient:
Adjust the shin guard to ensure shin guard rests against the
patient’s shins while patient is sitting with lower leg at 90° to
thigh where the thigh is parallel with the floor.
Shin Guard Adjustment Up/Down:
Adjust the shin guard to ensure the top of the shin guard is
at least 2 inches below the patient’s patella to avoid injury.
Figure 1
Figure 2a Figure 2b
