Page 15 of 18
52396 R00
5. At the sling bar end of the existing strap join the
new strap to it using two pieces of 1” wide x 9” duct
tape. Leave a ¾” gap between the two straps. Ensure
that the tape extends about an inch beyond the sewn
junctions of the straps.
6. Pull the new strap into place using the existing
strap by pulling on the anchor end of the existing
strap while feeding the new strap from the sling bar
end. Ensure the strap follows the route of the existing
strap and that it does not twist or have excessive
slack.
See next page
Duct tape (2)
Lift arm end roller
Lift arm elbow roller
Strap block roller (2)
Mast roller
Lift arm base roller
¾” gap
1” beyond
sewn junction
