WIRELESS CONNECTIVITY & SENSORS
User manual Thyone-I
4.4. Power up
After powering the module the
pin shall be held LOW for another
∆
t of 1ms after
the
is stable to ensure a safe start-up. In the command mode, the module sends a
on the
to indicated "ready for operation". This indication is done with
pin pulled to LOW in the transparent mode. See section
for more details regarding
the start-up sequence.
4.5. Quick start example
This section is intended to help the user set-up and test the exchange data between two
Thyone-I modules. Minimal pin and antenna connections have to be done on both the modules
as described in sections
and
. It is recommended to use the Thyone-I evaluation kit for
quick tests. Alternatively, the Thyone-I USB radio stick (USB dongle) can be used.
4.5.1. Prerequisites
The following hardware is required to go through the quick start example.
1. Two Thyone-I evaluation boards (or Thyone-I USB radio stick + evaluation board)
2. Computer with SmartCommander tool or any other a serial terminal emulator.
4.5.2. Hardware configuration
The Thyone-I EV board can be used in its default configuration to go through this example.
Refer to the Thyone-I evaluation board specific manual for a complete hardware description.
4.5.3. Set-up description
In this example, the Thyone-I EV boards are connected to the PC with Smart commander tool
installed (Figure
4.5.4. Start-up
1. Connect the Thyone-I EV boards to the laptop/PC via USB.
2. The power LED indicates that supply voltage is active.
The FTDI driver [1] for the converter IC on the evaluation board has to be in-
stalled and/or updated. On correct driver installation, the EV board appears as
a virtual COM port.
Order code 2611011021000
27
Version 2.3 , July 2022
