11
As shown in figure 4 connection method, correct connect to inlet pipe and
outlet pipe
Figure 4 correct wiring
Note:
①
according to Figure 4 correct wiring, do not connect inlet pipe and
outlet pipe wrong;
②
with the wrench to tighten nut joints of inlet pipe and SF6
device;
③
the other end of outlet pipe should be pointing downwind, or use
specialized equipment to collect waste gas.
3. Initialization
Turn on the power switch, the instrument into the initial interface, as
shown in Figure 5. In this process, the instrument will be self-calibrating
according to the state of sensors, at this time "status indicator" light flashes.
Self-calibration is completed, the "status indicator" light normally on.
Figure 5 initialization
