WS 5501 Series Manual Download Page 6

Page: 6 / 8

Lay the seat cushion (H) upside down on a firm surface.

NOTE:

for proper assembly of the chair it is important to

NOT

fully tighten any of the machine screws

installed in this step until all machine screws are installed.

Align the holes in the support plate attached to the back cushion (I) over the matching threaded inserts in the

seat cushion (H).

Insert and loosely tighten a

-20 x 1

” machine screw (1), a lock washer (3) and a flat washer (4) through

each of the four holes in the support plate and into the threaded inserts in the seat cushion.

Hardware used in Step 3

Summary of Contents for 5501 Series

Page 1: ... damaged DO NOT return to the store For immediate assistance with assembly or to order replacement parts please call 1 317 804 9160 THIS INSTRUCTION BOOKLET CONTAINS IMPORTANT SAFETY INFORMATION PLEASE READ AND KEEP FOR FUTURE REFERENCE ...

Page 3: ...LAT WASHER x 8 ALLEN WRENCH x 1 ARM CAP x 4 Hardware pack contains one extra of each of the machine screws and washers CASTERS x 5 5 STAR BASE x 1 TELESCOPING COVER x 1 GAS LIFT x 1 SEAT PLATE x 1 LEFT ARM x 1 RIGHT ARM x 1 BACK CUSHION x 1 SEAT CUSHION x 1 PARTS IDENTIFICATION ...

Page 4: ...e base When inserting the caster into the 5 star base apply a little pressure to the caster to pop it into position Turn the 5 star base right side up so the casters are on the floor Insert the large end of the gas lift D into the center hole in the 5 star base Place the telescoping cover C over the small end of the gas lift ...

Page 5: ... firm surface with the padded side down exposing the underside of the seat Align the holes in the seat plate E with the threaded inserts in the bottom of the seat H Insert four 1 4 20 x 11 4 machine screws 1 four lock washers 3 and four flat washers 4 through the holes in the seat plate and into the seat Tighten securely with the allen wrench 6 Hardware used in Step 2 ...