WRIGHT WSES36, Service Handbook

Page: 60 / 68

11.
Removing the Rear Lift-Axle Pins:
a. Remove both rear lift axle pins (Fig. 10, A) ; ensure deck weight is resting on
2X4’s.
b. Pry or punch pins to remove (Fig. 10, B) . Be careful as mower may shift when
pins are removed.
c. Drop rear lift axle and discard. (Fig. 10, C)
Installation of Improved Deck-Lift System
1.
Install New Rear Lift Axle and Rear Pins:
a. Install rear lift axle from the bottom of mower, lift evenly into place lining up rear
pin hole as close as possible.
NOTE: It may be necessary to spread the frame in the front to ease lift axle
into place.
b. Install rear pins from inside of the assembly. The 7/8” machined shoulder of the
pin should fit in the 7/8” hole in the frame sidewall originally used by the old pin
system.
c. Make sure the pin is flush with the face of the housing (Fig. 11, A) . Tighten with
¾” socket and wrench (Fig. 11, B)
Fig. 10, C
Fig. 10, B
Fig. 10, A
Fig. 11, A
Fig. 11, B
56