CAUTIONS BEFORE USE:
- Make sure that the power supply is appropriate for the cutter.As mentioned
previously, the cutter requires a three phase 380V,50/60Hz..
- Be sure not to cut material with diameter or hardness that exceeds the
machine's capacity. Otherwise,not only the blades could be damaged but
also it could result in troubles with interior parts of the machine.
- Don't use the machine in a rainy or damp area,or where it may become wet.
- If the blades is damaged,cracked or distorted, replace it with a new one of
WREN genuine blades immediately.Using of damaged blades could cause
trouble with the cutter.
- Before delivery,hydraulic oil is filled completely.
- Before inspecting, disassembling or replacing parts of the cutter, be sure
to disconnect the power cord from the outlet.
DOUBLE INSULATION:
The double insulation is such that two different insulating materials are
used between alive portion, such as a conductor through which a current
flowes and an outer frame accessible by the human body. A motor-driven
tool haveing such a double insulation is called "double-insulated" and
identified with a special marking.
In case of a double-insulated motor, for example,even if one of the two
insulation is broken down, the other insulation still provides a protection
against an electrical shock,thus ensuring the high safety of the operator.
For maintaining the effect of this double-insulation and ensuring the safe
use of cutter for along term, the with other than specified ones or to
incorrectly reassemble the electrical system of the cutter. Replacement
with other than specified parts or incorrect disassembling/reassembling
of the electrical system will cause the double insulation to be broken down,
possibly leading to unsafe operation of the cutter.
To avoid the above,only specialized persons have to disassemble or
reassemble the electrical system or replace the parts of the system.
CONNECTING THE SYSTEM:
The cutter head and power pack are connected by a 70Mpa operating
hose. End of hose will have one male and one female connector.
Connect the hose to cutter head and pump.
3
