IMPORTANT RECEIVING INSTRUCTIONS:
Visually inspect all components for shipping damage. If any shipping
damage is found, notify carrier at once. Shipping damage is NOT covered
by warranty.The carrier is responsiblefor all repair or replacement cost re
sulting from damage in shipment.
IMPORTANT SAFETY INSTRUCTIONS:
WARNING
:
Your WREN Rebar Cutter is a power tool.To prevent injury to
operator or any bystanders from flying steel fragments,strictly observe the
following:
1. Read ALL instructions.
2. Keep work area clean and well lit.
3. Always wear safety goggle sand full face shield when cuting.
4. Consider the safety of others when cutting.
5. Use extreme caution
- When cutting pieces under 20cm in length,
- Watch for possible flying fragments.
6. Before cutting,steel bar must rest fully within cutter blades.
7. Always adjust spacing bolt and tighten before cutting.
8. Keep fingers away from cutting edges during operation.
9. Avoid damaging hydraulic hose
- Avoid sharp bends and kinks when routing hydraulic hoses. Using a
bent or kinked hose will cause severe back-pressure. Also, sharp bends
and kinks will internally damage the hose leading to premature failure.
- Do not drop heavy objects on hose. A sharp impact may cause internal
damage to hose wire strands. Applying pressure to a damage the hose
may cause it to rupture.
- Do not use the hydraulic hose to carry a hydraulic component (i.e.
pumps, valves, cutter head)
10. Keep hydraulic equipment away from flames and heat.
-Excessive heat will soften seals, resulting in fluid leaks. Heat also
weakens hose materials and packings. For optimum performance DO
O
NOT expose equipment to temperatures of 70 C or higher.
11. To prevent electrical shock,do not use cutter in a damp are
a or where it may become wet.
SAFETY FIR
T !
S
1
