OPERATING PROCEDURE:
1. Make sure that switch trigger works normally by pulling and releasing,
before starting to cut.
2. Set the steel bar on the bar holder between the blades. Make certain the
bar is resting fully within the blades. Don't attempt to partially cut through
the diameter of the bar. This will cause damage to the blades and cause
the steel bar to fly out.
3. By pulling switch,the cutter rod with blade moves toward the bar and cut
the bar. Keep the switch pulled until the cutter rod stops at the end of its
stocke and cuts the bar completely.
4. Cutter rod is returning automatically when the switch is released after the
rod makes full cutting stroke. Hold switch long enough to complete the
cutting stroke,then release.
NOTE: The cutter rod will not his home position automatically unless the
switch is released on the way, because hydraulic control valve
will not to be opened on the way of the full stroke. Even if the
power switch is turned on before the cutter rod has fully returned
to the initial position, the cutter rod will not move forward.
5. Use of warn or chipped blades will damage the machine. Replace with
new blades before using again.
6. The machine will only operate properly if the hydraulic oil is at its proper
level. Check oil level periodically.
7. The cutting capacity of the machine is falling as its temperature is rising.
If the machine temperature reaches 70 C or higher, cutting operation
should be stoped to allow the machine to cool.
INSURE THE CONNECTORS ARE FULLY ENGAGED AND SCREWED
SNUGLY AND COMPLETELY TOGETHER.
4
