WIM-HB-000_A
Page
11
of
21
6.0
Assembly
6.1
Assemble Shaft to Rotor
6.1.1
Observe vanes & reference marks on rotors and determine direction parts should be assembled.
Care must be taken to ensure the correct directional relationship between the shaft and the rotors.
6.1.2
Coat shaft & bore with anti-seize compound and install. Press shaft through rotors one at a time.
Make sure that shaft is started in hole perpendicular to rotor face before completing press. Rotor
is positioned correctly once rotor contacts shoulder on shaft. Heating of rotor may be required.
6.1.3
Repeat when adding next rotor.
6.2
Brake Housing Assembly
6.2.1
Place
center ring flat, grease new O-Rings with Synxtreme HD-2/220 and then install both in center
ring. Start O-Ring in groove at one point and slide fingers over O-Ring as you travel around either
side meeting hands together opposite the starting point. O-Rings will fit snugly around inner wall of
grooves.
***CARE MUST BE TAKEN TO ENSURE CORRECT RELATIONSHIP
BETWEEN ROTOR/STATOR VANES AND DIRECTION OF ROTATION***
6.2.2
Position drive side stator on top of center ring. The 3” NPT inlet in center ring must be centered
among seven inlet holes along edge of stator face, likewise the 2” NPT outlet on center ring must
align with the one inlet hole along edge of stator face.
6.2.3
Grease O-Ring with Synxtreme HD-2/220 and install in center grove of stator.
6.2.4
Place drive side cap in position on top of center ring-stator assembly with the group of four
mounting bosses on cap surface nearest to the 3” NPT inlet. Bolt with 22
cap screws through holes in
center ring and secure with 22 lock washers and nuts on cap surface. Insert 12 cap screws and lock
washers into cap and tighten.
6.2.5
Place shaft into position of center ring/ stator cap.
