Scaler WallPlate HDBaseT Transmitter
16
5.1.7 Device Baud Rate
The default baud rate for the HDBaseT Transmitter is 9600. This can be changed to
accommodate various installation needs: 2400, 4800, 9600, 19200, 38400, 57600, and
115200.
Description
Command
Response
Change device baud
rate (xxxx = new baud
rate)
SET xxxx<CR><LF>
baud rate is set to
xxxx<CR><LF>
Get device baud rate.
GET BAUD<CR><LF>
baud rate is set to
xxxx<CR><LF>
5.1.8 Device Information
Description
Command
Response
Get firmware revision
REV?<CR><LF>
V1.0.3<CR><LF>
5.1.9 Factory Reset
The factory reset command will reset every setting to the factory defaults. EDID, HDCP,
scaling will be reset to the original settings. Use extreme caution when the device is
used in a live environment.
Description
Command
Response
Factory Reset
RST<CR><LF>
No response for 7 seconds
until device power cycles
5.1.10 EDID Configuration
The EDID settings listed below will only be passed to the HDMI input.
Description
Command
Response
UHD/30
EDID UHD<CR><LF>
EDID UHD!<CR><LF>
1080p
EDID FHD<CR><LF>
EDID FHD!<CR><LF>
720p
EDID HD<CR><LF>
EDID HD!<CR><LF>
Summary of Contents for TPHD462
Page 10: ...Scaler WallPlate HDBaseT Transmitter 5...
Page 30: ......
