8x8 HDMI 2.0 HDBaseT Matrix Switcher
60
9. Firmware Upgrade
Please follow the steps as below to upgrade firmware by the
FW
port on the rear panel:
1)
Prepare the latest two upgrade files and rename them as “08010000.APP” and
“08010000.APS” on PC.
2)
Power off the switcher, and connect the
FW
port of switcher to the PC with USB
cable.
3)
Power on the switcher, and then the PC will automatically detect a U-disk named of
“BOOTDISK”.
4)
Double-click the U-disk, a file named of “READY.TXT” would be showed.
5)
Directly copy one of two upgrade files (e.g. “08010000.APP”) to the “BOOTDISK” U-
disk.
6)
Reopen the U-disk to check the filename “READY.TXT” whether automatically
becomes “SUCCESS.TXT”, if yes, the firmware was updated successfully,
otherwise, the firmware updating is fail, the name of upgrade file should be confirm
again, and then follow the above steps to update again.
7)
Repeat step 5~6 to copy the other upgrade file (“08010000.APS”) to the
“BOOTDISK” U-disk.
8)
Remove the USB cable after firmware upgrade.
9)
After firmware upgrade, the switcher should be restored to factory default by
sending command.
