8x8 HDMI 2.0 HDBaseT Matrix Switcher
8
ALL IN port to all HDBaseT receivers.
⑦
IR OUT:
l
1~8: Eight 3.5mm jacks to connect eight IR emitters to send the IR signal
received from the corresponding HDBaseT receivers.
l
ALL OUT: 3.5mm jack to connect the IR emitter to send the IR signal received
from all HDBaseT receivers.
⑧
AC100V~240V:
Power port to connect an AC 100V~240V power by the power
cord.
⑨
GROUND:
Connect to earth to ensure the unit is well grounded.
3.3 Receiver Front and Rear Panel
①
Power LED:
The LED illuminates red when power is applied.
②
ARC Mode:
Press the button with paper clip or other sharp tool to enable the ARC
mode, and then the left LED illuminates blue. Press it again to exit the ARC mode
and the LED is off. When the ARC audio is selected as the audio source for the
SPDIF output of matrix switcher, the ARC mode will be enabled automatically.
③
ARC Audio In:
Toslink connector to connect ARC audio source device (e.g.TV).
④
FW:
Micro-USB port for firmware upgrade.
⑤
HDMI Out:
Type-A female HDMI output port to connect HDMI display (e.g.TV).
⑥
Audio Breakout:
If the ARC mode is OFF, the Toslink connector is connected to
speaker or amplifier for HDMI source audio de-embedding. Note that if the ARC
mode is ON, this port has no audio output.
⑦
IR In:
3.5mm jack to connect the IR receiver for IR pass-through.
⑧
IR Out:
3.5mm jack to connect the IR emitter for IR pass-through.
⑨
RS232:
3-pin terminal block to connect the RS232 control device (e.g. PC) or a
third-party device to be controlled.
1
2
3
4
5
6
7
8
9
11
10
