Installing or changing the batteries in the remote controller
Install the batteries as follows:
1. Open the battery
compartment on the remote
controller using a Phillips
screwdriver (not included) to
remove the screws on the
battery compartment cover.
2. Insert the batteries according
to the diagram. Ensure that the
positive and negative polarities
match the illustrations inside
the battery compartment.
3. Replace the battery
compartment cover and replace
the screws using the
screwdriver. Do not
over-tighten.
NOTE:
You will know when the batteries in the remote controller are nearly
depleted when Wrex the Dawg becomes less responsive to commands.
Important battery information
• Use only fresh batteries of the required size and recommended type
• Do not mix old and new batteries, different types of batteries [standard (Carbon-Zinc),
Alkaline or rechargeable] or rechargeable batteries of different capacities
• Remove rechargeable batteries from the toy before recharging them
• Rechargeable batteries are only to be charged under adult supervision
• Please respect the correct polarity, (+) and (-)
• Do not try to recharge non-rechargeable batteries
• Do not throw batteries into the fire
• Replace all batteries of the same type/brand at the same time
• The supply terminals are not to be short-circuited
• Remove exhausted batteries from the toy
• Batteries should be replaced by adults
• Remove batteries if the toy is not going to be played with for some time
• This user manual should be kept because it contains important information
Battery details
6
Underside of remote controller
