Program Mode
16
Program Mode
You can program Wrex the Dawg to perform a sequence of actions up to 80 steps.
The sequence can include movements, tricks and reset codes that will make him
perform animations (but not change his mode) as part of the sequence.
To program Wrex the Dawg, do the following:
1. Point the remote controller at Wrex the Dawg and press the
Program
button .
2. Enter commands using the remote controller. He will perform a few seconds of
the command and then store it as a program step.
3. If you do not enter a program step for approximately 30 seconds, he will store the
program and play it back. He will then exit Program Mode.
Alternatively, to store the program, press the Playback button . Wrex the Dawg
will play back the program and then exit Program Mode.
NOTE:
If you enter new program steps when a program is already stored, the new
program steps will be added to the previously stored program, up to 80 steps.
Wrex the Dawg will store the program, including when he is in Sleep Mode, until
he is turned off, unless you enter a new program.
To have Wrex the Dawg play back the stored program:
• Point the remote controller at him and press the
Playback
button .
NOTE:
Wrex the Dawg does not use Edge Detection or obstacle avoidance during
playback; ensure his surrounding area is free from obstacles and edges.
NOTE:
He will not play back the routine when he is in Guard Mode.
To delete the program:
• Enter Program Mode and then press the
Program
button twice quickly.
