1
)
Preparation
- Verify that the sealing
handle is positioned at the highest end of the guide.Switch on the machine via the switch
located at
the right
side
of
bottom part.
- The frontal green LED will fl ash.
It
means
preheating
.
- Heating resistance is powered and the temperature will increase gradually.
When the ideal level for proper welding is reached, the frontal green LED will remain fixed on.
3. O peration
2) Paper insertion
Have the paper belt pass under the paper-stop barrier and insert it in the rear slot. Then remove it from the front to the
desired length.You can
measure
the
size
of
sterilization
bag
which
you
need
before
sealing
and
cutting
.
3) Welding an end and cutting
- Lower the sealing
handle from position 1 to position 2.
The green LED will flash quickly until sealing has
finished, indicated by an acoustic signal.
- Slide the cutting handle to the opposite end.
- Lift the sealing handle from position 2 to the original position 1.
- The frontal LED will return to a fixed green once again, and the acoustic signal will switch off. The bag is now sealed
on one end.
7
BEEP
BEEP
1
2