Hedge trimmer
EN
12
HOW TO USE YOUR HEDGE
TRIMMER
Before cutting an area, inspect it first and remove
any foreign objects that could become thrown or
entangled in the blades. Always hold the trimmer with
both hands and with the blade away from you before
turning it on.
When trimming new growth, use a wide sweeping
action so that the stems are fed directly into the blade.
Allow the cutting blades to reach full speed before
cutting. When operating, keep the cutting blades away
from people and objects such as walls, large stones,
trees, vehicles, etc.
If the blade stalls, immediately stop the trimmer.
Release the two Switch Levers before attempting to
clear jammed debris from the cutting blades.
Wear gloves when trimming thorny or prickly growth.
Do not attempt to cut stems that are too thick for the
cutting blade.
Top cutting
Use a wide sweeping motion (See Fig. E1). A slight
downward tilt of the cutting blades in the direction of
motion gives the best cutting results.
Side cutting
When trimming the sides of the hedge, begin at the
bottom and cut upwards, tapering the hedge inward
at the top. This shape will expose more of the hedge,
resulting in a more uniformed growth
BATTERY STATUS (See Fig. F )
•
Before starting or after use, press the button
beside the power indicator light on the machine to
check the battery capacity.
•
During operation, the battery capacity will be
indicated automatically by the battery power
indicator. The indicator constantly senses and
displays the battery condition as follows.
•
For the machine with 2 battery packs with
different power, the power indicator light displays
the battery condition with the lower one of the
two batteries.
Battery indicator
light status
Battery condition
Five green lights
(
) are
illuminated.
The two batteries are in a
highly charged condition.
Two, three or four
green lights are
illuminated.
The two batteries have a
remaining charge. The more
lights are illuminated, the
more battery capacity.
Only one green
light (
) is
illuminated.
At least one battery is
almost depleted and needs
to be charged.
No light is
illuminated.
At least one battery is not
fully installed or battery may
be defective.
Only one light is
flashing twice per
cycle.
At least one battery is
over discharged (please
refer to the battery charge
condition), please recharge
the two batteries at once
before use again or storage.
Only one light is
flashing three times
per cycle.
At least one battery is hot,
wait for them cool down
before start again.
Only one light is
flashing four times
per cycle.
The machine is over load.
Remove tool from cutting
area and try again.
6. MAINTENANCE
Remove the battery from Hedge trimmer before
carrying out any adjustment, servicing or
maintenance.
There are no user serviceable parts in your power
tool. Never use water or chemical cleaners to clean
your power tool. Wipe clean with a dry cloth. Always
store your power tool in a dry place. Keep the motor
ventilation slots clean. Keep all working controls free
of dust.
7. ENVIRONMENTAL
PROTECTION
Waste electrical products should not be
disposed of with household waste. Please
recycle where facilities exist. Check with your
Local Authority or retailer for recycling advice.
