19
Cordless Chain Saw WG368E WG368E.9
and make cutting difficult.
After each use, with unit disconnected from power
source, clean all sawdust from the guide bar and
sprocket hole.
When rail top is uneven, use a flat file to restore square
edges and sides.
File Rail Edges
and Sides
Square
Worn Groove
Correct Groove
Replace the guide bar when the groove is worn, the
guide bar is bent or cracked, or when excess heating or
burring of the rails occurs. If replacement is necessary,
use only the guide bar specified for your saw in the
repair parts list or on the decal located
on the chain saw.
RePlAcING BAR & cHAIN
Fit the chain and guide bar as described in “Assembly
and Tensioning Chain”.
The circular groove of the guide bar will wear
particularly on the lower edge with time. When replacing
the chain turn the chain bar 180° to allow even wear,
thus extending chain bar life.
Check drive sprocket. If it is worn out or damaged due to
strain, have it exchanged by an authorized service agent.
If the chain bar is worn out or damaged, take the chain
tensioning catch off the bar by loosing the screw anti-
clockwise. Then fit the tensioning catch into the new bar
by tightening the screw clockwise. The catch protrude (a)
must be fitted into the bar hole. (See Fig. W)
SHARPeNING cHAIN
WARNING: Remove the battery pack from
the saw before servicing. Severe injury or
death could occur from electrical shock or body
contact with moving chain.
cutting edges on chain are sharp. Use protective
gloves when handling chain.
Keep chain sharp. Your saw will cut faster and more
safely. A dull chain will cause undue sprocket, guide
bar, chain, and motor wear. If you must force chain into
wood and cutting creates only sawdust with few large
chips, chain is dull.
lUBRIcAte SPRocket
WARNING:
Wear heavy duty gloves when
performing an maintenance or service to this tool.
Always remove the battery pack from the saw before
1
2
1/3
2/3
2
2/3
1
1/3
2
2
W
Y
Z
X
50 mm
50 mm
1
1
1
Z
Y
kg
Z
Y
a
a
K
L
M
N
O
P
Q
R
S
T
W
X
U
V