11
Cordless Chain Saw WG368E WG368E.9
WARNING: cutting edges on chain are
sharp. Use protective gloves when handling
chain.
WARNING: Maintain proper chain tension
always. A loose chain will increase the risk
of kickback. A loose chain may jump out of guide
bar groove. this may injure operator and damage
chain. A loose chain will cause chain, bar, and
sprocket to wear rapidly.
1. Place the chain saw on any suitable flat surface.
2. Turn the Chain Tensioning Knob (10) clockwise until
it is hand tight. The tension is automatically set while
the Chain Tensioning Knob is being tightened.
The ratchet mechanism (a) prevents the chain tension
from loosening. (See Fig. F1)
3. Double check the tension set by the automatic Chain
Tensioning Knob. The correct chain tension is reached
when the Chain (8) can be raised approx. 3-6mm
from the Guide Bar (7) in the center (the chain links
should just remain in the bar track). This should be
done by using one hand to raise the chain against the
weight of the machine. (See Fig. F2)
Use a screwdriver to move chain around Guide Bar
to ensure kinks do not exist. The chain should rotate
freely. (See Fig. F3 )
4. When the chain looses, unscrew the Chain Tensioning
Knob absolutely and then Screw on the cover plate
with the locking knob tightly again.
LUbRICATION
IMPoRtANt: the chain saw is not supplied
filled with oil. It is essential to fill with oil
before use. Never operate the chain saw without
chain oil or at an empty oil tank level, as this will
result in extensive damage to the product.
Note:
Chain life and cutting capacity depend
on optimum lubrication. Therefore, the chain is
automatically oiled during operation.
filling oil tank:
1. Set chain saw on any suitable surface with Oil Filler
Cap (4) facing upward.
2. Clean area around the Oil Filler Cap with cloth
unscrew cap.
3. Add bar and chain oil until reservoir is full. ISO VG32
Bar and chain oil of any brand can be used.
4. Avoid dirt or debris entering oil tank, refit the Oil
Filler Cap and tighten.
IMPoRtANt: to allow venting of the oil
reservoir, small breather channels are
18
17
7
8
12
16
14
13
a
2
3
3-6mm
11
10
11
19
A
B
C
D
E
F1
F2
F3
G
H
I
J