13
Cordless Chain Saw WG368E WG368E.9
push and slight pressure will be sufficient until a click is
heard. Check to see if the battery is fully secured.
Note:
When removing the battery pack, hold it
firmly to avoid dropping and injury.
4. BAtteRy StAtUS leD’S (See fig. H)
Note:
the Status leD’s will indicate the battery
condition when the button on the battery is
pressed.
The LED’s constantly senses and displays the battery
condition as follows:
Press the button “POWERTEST”, the light button is
illuminated.
When the three green lights are illuminated, the battery
is in a highly charged condition.
When two lights (
) are illuminated, the battery is in a
moderately charged condition.
When only one green light ( ) is illuminated, the
battery charge is depleted.
IMPoRtANt:
When only one light is illuminated,
your battery is overly discharged, even though
the tool may still be capable of working.
continuing to operate your tool with the battery
in this discharged condition may reduce the life
and performance of your battery.
5. SWItcHING oN AND off (See fig. I)
For switching on the machine, press the Lock-off Button
(3), then fully press the On/Off Switch (2) and hold in this
position. The Lock-Off Button (3) can now be released.
For switching off, release the On/Off Switch (2).
cUttING
IMPoRtANt:
Is the oil reservoir filled?
check the oil level Window (18) prior to
starting and regularly during operation. Refill
oil when oil level is low. A full oil tank will
last approx. 20 minutes depending on sawing
intensity and stops (See fig. J).
check recent replaced chain tension about every
10 minutes during operation.
1. Install the battery pack into the machine (See Fig. G).
2. Make sure section of log to be cut is not laying on the
ground. This will keep the Chain (8) from touching
the ground as it cuts through the log. Touching the
ground while the Chain is moving is dangerous and
will dull the Chain.
3. Use both hands to grip saw. Always use left hand to
grip front handle and right hand to grip rear handle.
Use a firm grip. Thumbs and fingers must wrap
around saw handles (See Fig. K).
18
17
7
8
12
16
14
13
a
2
3
3-6mm
11
10
11
19
A
B
C
D
E
F1
F2
F3
G
H
I
J
1
2
1/3
2/3
2
2/3
1
1/3
2
2
W
Y
Z
X
50 mm
50 mm
1
1
1
Z
Y
kg
Z
Y
a
a
K
L
M
N
O
P
Q
R
S
T
W
X
U
V