10
Electric Grass Trimmer
WG115E
AUTOMATIC LINE FEED SYSTEM
When you first switch on the trimmer, a small length of
line is fed out.
A ‘clattering’ noise will be heard for a short time. This
is normal and is caused by the line bumping up against
and being cut by the line cutter. Once the line is cut to
the correct length, the ‘clattering’ noise will stop and
the trimmer motor will run at full speed.
To feed more line, stop the trimmer completely, then
restart, allowing the motor to reach full speed. Repeat
this until you hear the ‘clattering’ noise of the line
cutting. (Do not repeat this procedure more than 6
times.)
MANUALLY FEEDING THE LINE (See Fig. E, F)
Press and release the manual line feed button, located
on the side of the cutting head, while gently pulling out
the lines until it reaches the line cutter.
When the required amount of line is fed out, gently
pull on the second line (there is no need to press the
manual line feed button again). If the line extends past
the line cutter, too much line has been fed out.
If too much line is fed out, remove the spool cap and
click the spool counter-clockwise until the line is at the
desired length.
1
2
10
11
12
14
13
E
F
G1
G2