13
High Frequency Multi-function Tool
EN
DISPOSAL OF AN
EXHAUSTED bATTERY
PAck
To preserve natural resources,
please recycle or dispose of
the battery pack properly. This
battery pack contains Lithium
batteries. Consult your local waste authority for
information regarding available recycling and/
or disposal options. Discharge your battery
pack by operating your tool, then remove the
battery pack from the tool housing and cover
the battery pack connections with heavy-duty
adhesive tape to prevent short circuit and
energy discharge. Do not attempt to open or
remove any of the components.
wORkING HINTS FOR YOUR
TOOL
If your power tool becomes too hot, especially
when used at low speed, set the speed to
maximum and run it with no load for 2-3
minutes to cool the motor. Avoid prolonged
usage at very low speeds. Always keep the
blade sharp.
Always ensure the workpiece is firmly held or
clamped to prevent movement.
Any movement of the material may affect the
quality of the cutting or sanding finish.
Start your tool before working and turn it off
only after you stop working.
Do not start sanding without having the
sandpaper fitted.
Do not allow the sandpaper to wear away , it
will damage the sanding pad. The guarantee
does not cover sanding pad wear and tear.
Use coarse grit paper to sand rough surfaces,
medium grit for smooth surfaces and fine grit
for finishing surfaces. If necessary, first make a
test run on scrap material.
Excessive force will reduce the working
efficiency and cause motor overload. Replacing
the accessory regularly will maintain optimum
working efficiency.
MAINTAIN TOOLS wITH
cARE
Your power tool requires no additional
lubrication or maintenance. There are no user
serviceable parts in your power tool. Never
use water or chemical cleaners to clean your
power tool. Wipe clean with a dry cloth. Always
store your power tool in a dry place. Keep the
motor ventilation slots clean. Keep all working
controls free of dust. Occasionally you may
see sparks through the ventilation slots. This is
normal and will not damage your power tool.
