Worx Landroid WR101SI, Instruction Manual

Page: 11 / 20

Lawn Mowing Robot EN
11
5.3 Cut to edge
Off-centered Blade Turning Disc (13) design, it provides a clean cut
with narrowest distance to the boundary or wall, it helps to minimize
the amount and frequency of manual trimming along the uncut area.
Additionally, the design with an underneath protective cover keeps
any object away from touching the turning blades in case of injury.
(See Fig. F)
5.4 Working time
The default daily working schedule is set for the first 4 hours for
working (mowing and charging included) and next 20 hours for
standby on the charging base, see below. The working schedule can
be re-set by using mobile apps (Only for specific model, please check
Technical Data & Declaration of Conformity), for downloading the app, please refer to section APP. Or you can re-set the
working schedule by removing and then installing the battery (please refer to Replacing the battery).
Working
Day 1 Day 2 Day 3
4h 20h 4h 20h 4h 20h
Standby Working Standby Working Standby Working Standby
Day 7
4h 20h
5.5 How efficiently will my Landroid
®
mow the grass?
Mowing times are different for every lawn depending on the factors mentioned below. Gradually adjust the time you allow
your Landroid
®
to mow each day until you find the most suitable setting.
Your Landroid
®
is capable of mowing areas of different sizes, although this depends on various factors, such as:
• Species of grass in your lawn and its growth rate
• Sharpness of the Cutting Blades (12)
• Humidity
• Surrounding temperature
• Amount of obstacles in your Lawn
Unlike the most other mowers, Landroid
®
uses side charging
system, which is able to cut the much surrounding grass as possible.
Additionally, the holes on the bottom of the charging base allow the
grass growing through which makes elegant appearance.
The Landroid
®
’s cutting height can be adjusted between 2cm-6cm.
Before starting your Landroid
®
for the first time, you should cut the
grass to the height no more than 9 cm. Then make sure you set the
cutting height to its maximum cutting height of 6cm (See Fig. G).
E1 E2
“Cut to Edge” Tech
F
G