Battery
Removal
Remove the seat and take down the right protecting plate.
Remove the battery from the battery case
（
1
）
.
Disconnect the battery negative (-) lead wire first and then the
positive (+) lead wire.
Remove the battery.
Warning!
During positive lead wire disconnection, be sure to prevent the tools being used from touching the frame; or it will
result in short circuit sparks, which may ignite gasoline and damage battery. It is dangerous!
Install the battery in reverse order of removal.
Warning!
To avoid short circuit, please connect positive (+) lead wire first,
then the negative (-) lead wire.
During the whole motorcycle adjustment, please do not
disconnect the battery, which may result in interior component
damage of the whole vehicle.
Battery charging (circuit voltage) inspection
Open the seat cushion and take down the right protecting plate.
Disassemble the battery from the battery case.
Disconnect the battery negative (-) lead wire first and then the positive (+) lead wire.
Remove the battery.
Measure the battery voltage using a voltmeter.
Fully charged: 13.1V
Undercharge: 12.3V
（
battery not work for one hour
）
* Attention
Voltmeter shall be used for charging inspection.
Charging
Connection method: Positive pole of battery charger is
connected to battery positive lead wire; Negative pole of battery
charger is connected to battery negative lead wire.
Warning!
• Battery shall be away from fire.
• Shut off charger switch first before or after charging in case sparks may be generated at connection parts, which