World Cat 2006 250 DC, Owner'S Manual

Page: 42 / 58

World Cat
5-7
NORMAL USE
Use the steps below for normal operation.
1. Hold the upper switch on the panel down for 5 seconds. This will purge the bowl and refill
it with water.
2. In the event of inclement weather or rough seas, use the lower switch to remove water
from the bowl and prevent sloshing.
DECK PUMP-OUT
Upon returning, use the following instruction to empty the holding tank.
1. Remove the cap from the deck pump-out fitting located on deck, forward of the port berth
entrance.
2. Use the vacuum hose at the pump-out station to clean the tank, then remove the hose and
replace the deck fitting.
OVERBOARD DISCHARGE
Use the following steps to discharge the contents of the holding tank overboard:
1. Access and open the ball valve connected to the discharge side of the macerator pump by
removing the aft berth cushion and stoage compartment lid.
2. Use the “Accy 2” switch on the digital pod located near the helm to evacuate the tank. The
discharge thru-hull is located inside the tunnel on the starboard sponson.
3. Inspect the tank level and repeat step 2 if needed, otherwise close the discharge seacock.
For more instructions on operation, winterization and troubleshooting the marine head, see the Jabsco™ manual
supplied in your “Owner’s Portfolio”.
! CAUTION
Large quantities of waste or paper can clog the head and cause odor issues. To prevent this, flush
often and if necessary perform an extra flush to purge the discharge line.
! CAUTION
Do not dispose of foreign objects in the head. Doing so may damage the macerator pump or outlet
hoses. Clogging or puncturing these lines will lead to odor problems.
! CAUTION
Discharging waste in inland waters and some coastal areas is illegal. Check with local and state
authorities in your region to determine the proper method for waste disposal.