4
Workrite Ergonomics 800.959.9675 www.workriteergo.com
Workrite Sequoia Monitor Arm - Assembly Instructions
Assemble Desk Mount
1
Install the Extension Pole (A) into
the threads in the mount and tighten
securely.
Insert 2 Set Screws (G) into the rear
of the base and tighten securely with
the 2.5mm Hex Wrench (I)
2
b
b
a
a
Attach Extension Pole, Cable Manager & Collar
Heavy Duty C-Clamp Mount:
Note: If you have easy access you can assemble the
clamp before placing it onto the work surface and
tightening it down.
Place the Clamp Base (TT) over the rear edge of the
workstation. Attach the Clamp Bracket to the Clamp
Base with 4 M6 × 10mm Alan Cap Bolts (V) and
tighten with the 6mm Hex Wrench (S)
Grommet Mount:
Note: A grommet hole or small drilled hole from 3/8”
diameter to a grommet hole up to 2.5” diameter is
required to mount the grommet mount.
Place the Grommet Mount Base (U) over the
grommet hole or drilled hole in the worksurface.
From the bottom place the bolt (X) through the
Grommet Clamp Plate (W) and tighten securely with
the 6mm Hex Wrench (S)
Install Cable Manager (B) onto the
Pole and slide down to the bottom.
Place Collar (C) onto the pole about
6” up from the bottom and install Set
Screw (G) and tighten securely.
S
U
W
X
B
I
C
V
S
T
T
G
G
G
A
