10
Workrite Ergonomics 800.959.9675 www.workriteergo.com
Workrite Sequoia Monitor Arm - Assembly Instructions
Attach Center Monitor to Capped Pole
Attach Outside Monitors to Wing Bars
11
12
a
a
b
b
a
b
c
Place Center VESA Mount (J) on Capped Pole
and rest on Wing Mount.
Install Ratchet Lever (D) into the rear of the
Center VESA Mount and tighten.
Note: It’s a combination of the Ratchet Lever,
Wing Mount AND the Collar that holds the
monitor in place.
Note: During installation it may be necessary
to adjust overall height of the assembly. To
do this simply loosen the Set Screw (G) in the
Collar(C) with the 2.5mm Hex Wrench (I) and
move accordingly. Retighten the Set Screw
and Wing Bar Mount when desired height is
reached.
Align the Outside VESA Mount (K) with the
slit in the Wing Bar. Place Plastic Washer (E)
onto the Mount Knob (F). Install the Knob and
Washer into the Mount as shown and tighten
securely.
Repeat for the remaining outer monitor
Note: During assembly it may become
necessary to adjust the width of the outer
monitors to adjust for curved alignment and
minimize gaps between monitors. To do this
simply loosen, move, and retighten the Mount
Knob (F) to the wing bars.
c
a
F
E
K
F
J
D
