&
Workrite Ergonomics 800.959.9675 www.workriteergo.com
11
Workrite Sequoia Monitor Arm - Assembly Instructions
Make Adjustments & Secure Cables
13
Horizontal adjustments is made by using the VESA Mount Knob (F)
and vertical adjustment is made with Ratchet Lever (D). You may
need to re-position the Collar (C) to lower or raise the Wing Bar on
the Pole.
Arc adjustment is made by pulling the Wing Mount monitors towards
you or pushing away from you.
Guide monitor and power cables over and around
Ratchet Levers and Wing Knobs then through the
Cable Manager (B).
Monitor Tilt & Swivel Adjustments
Depending on the size of your monitor, it may be necessary to adjust
the tilt and swivel setting.
If the monitor doesn’t hold its tilt position or is too hard to tilt, adjust
the tension adjustment on top of the Monitor Mount. Use the 2.5mm
Hex Wrench (I), clockwise to increase lift, counter-clockwise to
decrease lift. Check the monitor, and adjust again as necessary.
a
b
c
Swivel
+/- 20°
Tilt
+/- 20°
Horizontal Adjustment
with VESA Mount Knob
Vertical Adjustment with
Ratchet Lever & Collar
Arc Adjustment
+/- 10°
Important Note
It is recommended to have two people adjusting multiple monitor
configurations after monitors are mounted to the arm assembly.
!
B
B
I
J
K
