6
1
2
3
4
5
6
7
8
9
10 11
12
13
14
15
16
17
18
1. Print Head Selector Switch:
Each print head has its own selection switch that is independent of all others and may be set in any
one of the following positions; OFF - Single, Print Stroke & Double Stroke. During a print cycle those heads in the OFF position will
remain at rest. The remaining head(s) will print after the pallet table has raised up, then upon completion the pallet table will
lower and rotate to the next station while the flood stroke is occurring. If a double print stroke is required for any head(s), the
pallet table will not rotate after lowering but will rise again in the same position for the second print cycle before continuing to the
next station.
2. Manual Print Buttons:
Each print head has its own numbered button, when one is depressed the pallet table will raise and the
corresponding print head will print. The table will then lower but no table rotation will occur (used primarily to check registration).
3. Emergency Stop Button:
When activated the air pump valve will cycle and release all air from the printer and cut power to all
systems. (Note
It is very important that the table be in alignment before reenergizing the emergency stop
).
4. In Position Indicator:
Before the press can begin any cycle or command the press must be “in position” meaning the correct
sensors are reading for the command to begin.
5. Front/ Rear: Front Position;
The squeegees will remain in the printed-rear position to leave the screen flooded for air dry inks.
Rear Position;
The squeegees will remain in the flood-front position to leave the screen opened and not flooded, used for most non
air-dry inks such as plastisol.
6. Table Up/Down:
In manual mode this will manually raise the table or lower the table, generally used during setup or
registration.
7. Print On/ Off:
I
f a squeegee requires service , the activation of this switch will release the air to the print cylinders so that the
squeegee may be removed for cleaning, revised, replaced or to be able to adjust the squeegee angle and pressure adjustment. Flip-
ping the switch to the original position will again supply air to the heads allowing operations to continue.
8. Sample:
After registering a job it may be necessary to run a single sample to verify proper registration. Load test canvas, turn the
sample on and the machine will print once on ever head that is turned on.
Summary of Contents for Freedom 6/8
