Workhorse Freedom 6/8, Owner'S Manual

Page: 21 / 22

21
MAINTENANCE AND UPKEEP
lubricating should be performed a minimum of every 5,000 prints. Grease the aluminum track that the indexing carriage travels in.
Place a small amount of white lithium grease on your finger and apply to the inside of this track in the grooved area that the
bearing plastic carriage slides in.
Make sure that the Chiller on your air supply has the capacity to do an effective job. Water in the air can reduce the efficiency of
the printer and cause expensive service problems in the future. Failure of the printer due to moisture in the air supply is not
covered by the manufactures warranty.
NOTE: Water is your pneumatic system's worst enemy! You must always ensure that the air being delivered to your press is free of
any moisture. Regularly check your Chiller for proper operation. Drain your compressor daily. Change the filter in the eliminator a
minimum of every 4 months.
If you see milky fluid in either side of your F.R.L. (Filter, Regulator and Lubricator), your air-drying system has failed! Failure to
maintain your press and failure to keep detailed maintenance records could void your warranty!
Questions? Give us a call!
800.778.8779
workhorseproducts.com
Visit our website at