Non-use Periods:
The power cord of the appliance should be unplugged from the outlet when left unused for
a long period of time.
Object and Liquid Entry:
Care should be taken so that objects do not fall and liquids are not spilled into the enclosure
through openings.
Damage Requiring Service:
The appliance should be serviced by qualified service personnel when:
-The power supply cord or the plug has been damaged; or
-Objects have fallen,or liquid has been spilled into the appliance; or
-The appliance has been exposed to rain; or
-The appliance dose not appear to operate normally or exhibits a marked change in
performance; or
-The appliance has been dropped, or the enclosure damaged.
Servicing:
The user should not attempt to service the appliance beyond that is describedin the
Instructions.All other servicing should be referred to qualifield service personnel.
Operating
2
R
EAR PANEL CONTROLS
1.CHIME REMOTE TERMINAL
2.P.T.T1
IMPORTANT NOTICE
3.MIC/LINE INPUTS 2~5
IMPORTANT NOTICE
4.MIC INPUTS 6~9
IMPORTANT NOTICE
5.LINES 6~9
6.RECORDING
7.OUTPUTS L,R
8.DC POWER
IMPORTANT NOTICE
9.AC POWER
This is a terminal for chime signal.
Connect this terminal with priority and chime controls are activated from P.T.T remote and
microphone cable with shield can extended at the MAX 30m.
Be sure not to make a shorten to the ground because microphone
, - is for operating power of condensor microphone.
MIC/LINE balanced input can be selected by mode switch in the front panel.
When you select MIC input,operating voltage is only for condensor
microphone if you connect dynamic microphone balanced by mistake,microphone will be
out of work also, be sure not be insert mic input connector under level volume-up, speaker
systems may get damage due to big noise.
MIC input 6~9 balanced are only for microphone input.
When you select MIC input,operating voltage is only for condensor
microphone if you connect dynamic microphone balanced by mistake,microphone will be
out of work also, be sure not be insert mic input connector under level volume-up, speaker
systems may get damage due to big noise.
LINE 6~9 unbalanced two, Left, Right RCA jacks are converted into mono in the internal
circuit all line input
10dB(245mV) input level are for CASSETTE DECK,CD,DAT DECK,TUNER.
Recording outputs two Left, Right unbalanced RCA jacks are converted into stereo signals in
the internal circuit from mono signal. Recording output volume can not be controlled by
master volume controller because circuit of recording output controls is just in the before
master volume controls.
This is master outputs which can be selected by switch.
This is a connector unexpected AC failure. Built in fuse PCB F902<T0.5AH 250V (55T)>.
Be sure not to make a shorten for battery and polarity of battery.
Be sure to Check AC voltage.
PUSH
PUSH
PUSH
PUSH
PUSH
PUSH
PUSH
PUSH
OUTPUT
WARNING:
TO REDUCE THERISK OF FIREORELECTRIC
SHOCK DON'T EXPOSE THIS EQUIPMENT TO RAINORMOISTURE.
CAUTION
RISKOFELECTRICSHOCK
DONOTOPEN
9
REC
Line 9
Line 8
Line 7
Line 6
DC POWER
24V MAX 0.45A
1
2
+
MIC INPUTS
MIC LINE INPUTS
2
3
4
5
6
7
8
3
P.T.T. 1
GND
PRIORITY
CHIME
LEDPWR
1
2
3
4
5
6
7
MICINPUT
+
G
-
1
2
3
4
5
6
7
Chime
Remote
1
2
3
4
5
6
7
1
2
3
4
5
6
7
8
9
5
