13
12
12
Electric Pressure Washer
EN
TROUBLESHOOTING
Symptom
Possible causes
Solution
Machine does not start
when the switch is in”
I”position.
Power cord is not plugged in.
Plug in power cord.
Socket is defective.
Check or replace plug, socket, fuses.
GFCI is triggered.
Press reset on GFCI plug.
Machine pressure is
not consistent.
Pump is faulty.
Contact service center .
Air in line.
Remove the nozzle, turn on the machine and allow low
pressure water to flow for a while and install the nozzle
back.
Water inlet adapter is clogged or dirty.
Remove the adapter, rinse it with water and put is back.
The pressure of the
pump is not adequate
Water supply is Insufficient.
Open water source completely.
Water supply is restricted.
Check If the water hose kinks or leaks.
Diameter of garden hose is too small.
Replace with right garden hose .
Leak or kink in hose .
Replace hose or untie kinks in hose.
No detergent
Wrong nozzle is attached
Attach the soap nozzle
Lance leaks
O-ring needs to be replaced.
Replace O-ring .If the problem is not solved ,contact
service center to buy a new lance.
Summary of Contents for WG607
