PAGE 4
User Manual
/ Manual de uso
REAR PANEL
14
20
15
12
13
16
17
18
19
AC IN connector
Caution
[SPEAKERS]
output
terminals
DIP switches
[OUTPUT]
[RS485 input (RJ45 connection)]
[LINE OUT]
[SETUP]
switch
Connect the supplied power cord.
·
When connecting the power cord, connect the power cord to the connector and then plug
it into an appropriate AC power outlet.
·
Before connecting or disconnecting the power cord, make sure that the power to the
device is turned off.
Barrier strip type speaker output connectors. Refer to “Connecting Speakers” for
the installation instructions.
Sets the output type of amplifier: high-impedance connection ([100V], [70V]) or
It is possible to send RS485 commands from an external device in order to control
low-impedance connection ([8
Ω
16
Ω
]).
several function in the amplifier .
12.
13.
14.
15.
16.
17.
Allows to set some functions (Check
DIPSWITCHES FUNCTIONALITY
section)
RCA type stereo output jack (unbalanced output). Allows to send preamplified signal
to another amplifier.
EN
G
L
L
L
R
R
R
SPEAKERS
DCP
SETUP
[INPUT 2 & 3]
These stereo RCA connectors (unbalanced) correspond to INPUT 2 & 3. They accept LINE level
18.
[MIC INPUT SIGNAL]
Terminal block that accepts microphone input level.
19.
[MIC LEVEL]
knob
Adjusts the MIC input volume. Turning to the right increases the level.
20.
Change the setting depending on the speaker connection (high- or low-impedance
connection).
·
Before connecting speakers, make sure that the power of the device is turned off.
If the power is on, there is a risk of
electrical shock.
·
In a high-impedance installation, make sure that the sum of the power input
ratings of the speakers to be connected does not exceed 100W.
·
In a low-impedance installation, make sure that the total impedance of speakers
to be connected is at least 8 ohms.
CONNECTING SPEAKERS
CAUTION
PA 100 MX
