12
Charging/locking the battery:
The battery may not leave us fully charged.
You should fully charge the battery before using your
bike.
The battery can be charged on the bike or it can be removed and charged separately. The socket
used to charge the battery is located on the underside of the frame as shown below.
Ensure that the
charger is
switched OFF
before attaching the charger to the bike.
You should keep the battery
topped up and not let it go completely flat to ensure it stays in the best condition for as long as possible.
Once the charger has been attached and switched on at the mains, the light on the charger will go
RED
to
indicate that it is charging the battery, when charging is complete, this light will go
GREEN
.
If you wish to remove the battery from the bike to charge it in another location such as indoors or at the
office, insert the key into the hole on the underside of the frame as indicated below and unlock the battery.
Next you will need to open the clamp and at least partially fold the bike to allow enough room for the bat-
tery to be slid out from the frame. Lift out the small handle and then slide the battery out. If you have any
difficulty sliding the battery out, check that battery is properly unlocked, there is a brass bolt that when
locked protrudes through the frame from the right-side of the battery (see next page), this must be fully
retracted for the battery to be able to be removed. If it is not fully retracted, you may need to turn the key a
little more until it is fully retracted.
A full charge from flat can take up to 8 hours.
